Service manual

64
Disassembly Procedures
Figure 2. End Cap Latch
Figure 3. Front of End Cap Release
Figure 4. Rear of End Cap Release
Figure 5. End Cap Alignment Locator
8. End Cap Removal
8.1 The latches on the end cap need to be released
from the console base. See Figure 2.
8.2 Turn the console upside down.
8.3 Press a flat blade screwdriver in-between the
console base and the front of the end cap. Once the
screwdriver is between the end cap and base, rotate
the screw driver downward to loosen the front end
cap latch. See Figure 3.
8.4 Press a flat blade screwdriver in-between the
console base and the rear of the end cap. Once the
screwdriver is between the end cap and base, rotate
the screw driver downward to loosen the rear end
cap latch. See Figure 4.
8.5 Once the both ends of the end cap are released,
slide off the end cap.
9. End Cap Replacement
9.1 With the console right side up, slide the end cap
onto the side of the base. Be sure to engage all end
cap latches into the base.
9.2 Press downward on the end cap until the flat
edges of the end cap alignment locator is flush with
the bass. See Figure 5.