Service manual

62
Disassembly Procedures
1. Top Cover Assembly Removal
1.1 Remove the 6 screws located on the bottom of
the console as indicated.
1.2 Lift off the top cover assembly.
Important Note: When replacing the top cover,
press down on the top cover before tightening the
screws. Do this to avoid the screw having to take up
the pressure of the cover shield against the base
shield. Failure to do so could result in a stripped
screw.
2. AUX/Tuner PCB Removal
2.1 Remove the two screws indicated.
2.2 Remove the four cables from the AUX PCB
connectors.
2.3 Remove the two screws securing the J700
connector block to the rear panel.
2.4 Lift up the AUX PCB.
Important Note: When replacing the AUX PCB,
align the J700 connector block to the rear panel
before securing it with the screws. Do not allow the
rear panel to touch the AM/FM connector shields.
Center the PCB screw holes to the screws bosses
in the base.
3. Zone 2 PCB Removal (AV35 Only)
3.2 Remove the three screws securing the RCA
block to the rear panel.
3.3 Remove the three screws securing the Zone 2
PCB bracket to the rear panel.
3.4 Lift out the Zone 2 PCB.