Operation Manual

14
System Setup
4. On the Acoustimass
®
module, insert the right-angle connector (Figure 11) of the Acousti-
mass module cable into the jack labeled MEDIA CENTER. On the rear panel of the media
center, insert the other end of the cable into the jack labeled ACOUSTIMASS MODULE.
Firmly tighten the two screws at each end of the cable.
Figure 11
Right-angle connector that
attaches to the Acousti-
mass module
5. On the rear panel of the media center, insert one end of the supplied video cable (marked
in yellow) to VIDEO OUTPUT (Figure 12). Insert the other end of the cable into the video
input on your TV.
CAUTION: Do not plug the Acoustimass module into an AC power (mains) outlet until all the
components are connected.
Figure 12
Basic connections to the
media center
Note: Before using your TV to play a DVD or other video source, be sure to read the Impor-
tant Note on page 16.
S-video as an alternate means to connect to the TV
An S-video input jack, provided on many TVs, delivers a higher-quality TV picture than the
composite video output connection shown above.
To make this alternate connection, insert the end of an S-video cable from the TV into the S-
VIDEO OUTPUT on the media center. This cable may be purchased from your Bose
®
dealer or
a local electronics retailer.
L
R
L
R
D
D
L
R
C
S
C
S
L
R
VIDEO IDEO 2 AUX
AUDIO INPUT
AUDIO
OUTPUT
VIDEO
OUTPUT
VIDEO
INPUT
OPTICAL
75
Ω
FM
ANTENNA
AM
LOOP
ANTENNA
SPEAKERS
ACOUSTIMASS MODULE
D
AC INPUT
MUSIC CENTER
RIGHT
LEFT
Speaker
cable
Acoustimass
module cable
video input
To TV
AC input
VIDEO OUTPUT
jack
AM256950_02_V.pdf • January 29, 2002