Operation Manual

en Cleaning and maintenance
30
Filter in the water inlet hose
blocked
:Warning
Danger of death!
Do not immerse the Aqua-Stop safety
device in water (it contains an electric
valve).
First, reduce the water pressure in the
supply hose:
1. Turn off the tap.
2. Select any programme (except Spin
/Drain 0/[).
3. Select A (Start/Reload). Allow the
programme to run for approx. 40 s.
4. Turn the programme selector to Off.
Pull out the mains plug.
5. Clean the filter on the tap:
Disconnect the hose from the water
tap.
Clean the filter with a small brush.
6. Clean the filter on the back of the
appliance:
Remove the hose from the rear of
the appliance.
Take out the filter with pliers and
clean it.
7. Connect the hose and check for
leaks.