Operation Manual

Cleaning water inlet

strainers

This is necessary if very little or no water flows into the

washer-dryer.

First, reduce the water pressure in the inlet hose:

■ Turn off the tap.

■ Turn the programme selector to any programme

(except Spin Í/ Drain [).

■ Touch the Start/Pause A button, and allow the

programme to run for approx. 40 seconds.

■ Turn the programme selector to Off.

Cleaning the strainer at the

water tap

■ Disconnect the hose fror the water tap.

■ Rinse the strainer under flowing water.

■ Connect the hose.

Cleaning the strainer on the

washer-dryer

■ Disconnect the hose fror the back of the

washer-dryer.

■ Pull out the strainer and rinse under running water.

■ Insert the strainer and reconnect the hose.

■ Turn on the water tap and check whether water is

still discharged. If water is leaking, check that the

filter is correctly seated.

■ Turn off the tap.