Operation Manual

Before using your washer-dryer for the first

time

Preparing your

washer-dryer

Caution

The washer-dryer must have been installed and

connected properly (refer to page 53).

² The washer-dryer was tested before leaving the

factory. To remove any water left over from testing

procedures, the first washing cycle should be

carried out without laundry in the machine.

■ Turn the tap on.

■ Pull out the detergent drawer all the way.

■ Pour approx. 1 litre of water into chamber II of the

detergent dispenser.

■ Half fill the measuring beaker with detergent and

pour into chamber II.

² Do not use any special detergents for delicates or

woollens (excessive foam).

■ Close the detergent drawer.

■ Close the washer-dryer door.

■ Set the programme selector to Cottons ic with

washing temperature 90°C.

■ Touch the Start/Pause A button. The programme

starts.

The programme ends when the programme duration is

on -0-:

■ Turn the programme selector to Off.