Specifications

17
Operation
Channel Select (WM2000 Only)
To change the WM2000 channel, do the following:
> Tap the Ch Select key to select channel 1 or 2.
The key is green when channel 1 is selected and red when channel two is
selected.
Receiving Calls
When there in an incoming call signal the Call key flashes red. There is also a beep
tone in the headphones if the beep feature in activated, see “Incoming Call Beep (DIP
Switch 3)” on page 6.
Incoming call indication is provided only for the currently selected channel on the
WM2000 unit only.
To receive calls, do the following:
1. Turn on the talk and listen keys to begin your conversation.
NOTE: You can turn the talk and listen keys on in either momentary or latched
mode. For latched operation, tap the key to turn it on. Then, tap it again
to turn it off, when finished.
Calling an Intercom Channel
To make a call, do the following:
1. Select the desired intercom channel (WM2000 only).
2. Press and hold the call key.
An inaudible call signal will be sent, and the Listen key automatically turns
on.
3. Release the call key and activate the talk key when a call is received.
4. Turn off talk and listen keys to end the conversation.
93507621000 WM10002000UserManual.book Page 17 Monday, April 27, 2009 3:09 PM