Installation Guide
35
Error messages
Customer service
Contact the Customer Service department if your
appliance needs repair. Our representatives will be
happy to provide details for an authorized service
provider close to you.
E-Nr. and FD (serial) number:
When you contact Customer Service, please have the E-
Nr. (model number) and the FD (serial) number for your
appliance available. You can find the identification plate
with these numbers on this information on inside of the
appliance door or on the back of the appliance.
Questions? Please contact us. We look forward to
hearing from you!
Display Fault Measure
è flashes
Door not closed properly. Check to be sure no laundry is caught in the washer
door. Close the door securely.
r
Cold water tap not turned on. Turn on the cold water tap.
Supply hose for cold water kinked
or pinched closed.
Eliminate the cause, replace the hose if damaged.
Strainer in water supply hose
clogged.
Clean the water inlet strainer.
~ Cleaning the water inlet strainers; Page 29
Cold water pressure too low. Eliminate the cause.
E:93 Hot water tap not turned on. Turn on the hot water tap.
Supply hose for hot water kinked or
trapped.
Eliminate the cause, replace the hose if damaged.
Hot water pressure too low. Eliminate the cause.
Supply hose for hot water not con-
nected correctly.
Connect both supply hoses (hot and cold water) for
hot water appliances. ~ Water connections; Page 13
E:32
(alternating display with
END when program is
finished)
Not a fault – the unbalanced load
detection system has interrupted
the spin cycle because the laundry
is unevenly distributed.
Distribute small and large items of laundry evenly in
the drum. If necessary, start an additional spin pro-
gram.
E:18 Too much detergent used or non-
HE detergent used.
Use less detergent for future loads. Only use HE deter-
gents.
~ Your washing machine is intended for; Page 5
Pump is blocked (obstructed). Clean the washer drain hose and/or the drain pipe.
May need to perform pump maintenance to clear
blockage.
~ Cleaning the drain pump; Page 30
Others Turn off machine, wait 5 seconds and turn on again. If
the display shows again, call customer service.
0DLQ6WUHHW6XLWH
,UYLQH&$
ZZZERVFKKRPHFRP