Specifications

EN | 82 Installation and Operating Manual | VIP X1600
Configuration using a Web Browser Bosch Security Systems | 2006-03 | V2.0
Network
The settings in this screen are used to integrate the VIP X1600 module into an
existing network.
Caution
Changes to the IP address, subnet mask or gateway address are trans-
ferred to the unit by clicking Set. However, they only take effect after the
unit is restarted.
– Click Set after entering a new IP address.
– To restart the device, enter the old IP address followed by /reset (for exam-
ple 192.168.0.16/reset) in the address bar of your Web browser.
The VIP X1600 module restarts, after which it can only be accessed at the
new IP address.
IP address:
Enter the desired IP address for the VIP X1600 module. The IP address must be
valid for the network.
Subnet mask:
Enter the appropriate subnet mask for the selected IP address here.