Specifications

Bosch Security Systems | 2006-03 | V2.0 Installation
VIP X1600 | Installation and Operating Manual EN | 17
Installation 4
The VIP X1600 modules are solely intended for installing in the VIP X1600 base.
Installing the units is a quick and easy operation that does not require any addi-
tional tools.
The VIP X1600 is designed for installing in a switch cabinet. Mounting the unit
in a 19-inch rack using the installation material supplied is a quick and easy
operation.
It is also possible to operate this as a desktop unit. The four elastic bumpers pro-
vided with the components supplied ensure a non-slip support.
General installation conditions
Caution
The VIP X1600 is designed for indoor operation. Select a suitable location
for installation where the unit will not be subjected to conditions of extreme
temperature or humidity. The ambient temperature must be between 0 and
+50 °C (+32 und +122 °F), and the relative humidity between 20% and
80% (non-precipitating).
The VIP X1600 generates heat during operation. During installation,
please note the maximum heat value of 205 BTU/h.
Please ensure the following installation conditions:
❚ Do not install the VIP X1600 close to heaters or other heat sources.
Avoid locations exposed to direct sunlight.
❚ Allow sufficient space for running cables.
❚ Ensure that the VIP X1600 has is adequate ventilation. Bear the total heat
output in mind, particularly when installing multiple units in a switch cabinet.
❚ When making connections, use only the cables supplied or use appropriate
cables immune to electromagnetic interference.
❚ Position and run all cables so that they are protected from damage, and pro-
vide adequate cable strain relief where needed.