Installation Guide

AutoDome 100 Series Fixed Camera Installing Roof Parapet and Pipe Mounts | en 49
Bosch Security Systems, Inc. Installation Manual F.01U.217.818 | 1.0 | 2011.04
6. To connect supervised alarms and relays, attach the appropriate wires to their terminals
on the P104 connector on the Pipe Interface Board (see Figure 3.11, above). In addition,
refer to Section 6 Alarms and Relay Connections, page 69 for more details on wiring alarms
and relays.
Note: There is a slot located at the top of the Interface Board to tie the wires to the
circuit board with a cable tie.
7. Insert the Pipe Interface Board into the down pipe and fasten the three (3) retaining
screws to secure the board to the Dome Cap.
Figure 3.12 Pipe Interface Board to Dome Cap Assembly
CAUTION!
Be careful not to strip the threads when tightening the Pipe Interface Board retaining screws.
1 Interface Board
2 Retaining Screws (3)
3 Pendant Mounting Screws (2)