Installation Guide

AutoDome 100 Series Fixed Camera Installing Roof Parapet and Pipe Mounts | en 37
Bosch Security Systems, Inc. Installation Manual F.01U.217.818 | 1.0 | 2011.04
3.4 Route Wires and Attach Connectors
Power wires must be routed to the left (front) side of the Power Supply Box through a
separate conduit. All video, control, and alarm wires must be routed through a second conduit
to the right side of the box. Refer to Section 5 Cable and Wire Standards, page 61 for methods
of transmitting video and data, and for wire specifications.
3.4.1 Methods for Routing Wires
There are two possible methods to route the video, control, and alarm wires:
– One is to route the video, control, and alarm wires through the conduit fitting on the right
(front) side of the Power Supply Box and out to the AutoDome Interface Board.
Figure 3.3 VG4-A-PSU1 or VG4-A-PSU2 Power Supply Box
WARNING!
External interconnecting cables are to be installed in accordance to NEC, ANSI/NFPA70 (for
US application) and Canadian Electrical Code, Part I, CSA C22.1 (for CAN application) and in
accordance to local country codes for all other countries.
Branch circuit protection incorporating a 20 A, 2-pole Listed Circuit Breaker or Branch Rated
Fuses are required as part of the building installation. A readily accessible 2-pole disconnect
device with a contact separation of at least 3 mm must be incorporated.
1 120 VAC/230 VAC Power In 5 Coax, UTP Video, or Ethernet Wire
(Ethernet for VG5 700 Series only)
2 P101 Connector 6 Control Wire
3 Ground Connection 7 24 VAC Power Out
4 Transformer 8 P107 Connector
GND TXD RXD  C+ C-GND TXD RXD  C+ C-
P101
P106 P105
P107
XF102 XF103
XF101
5 4 3 2 1
J
J
J103
J
1
0
2
J101
(LED)
HTR DOME
24V NC 24V
(
FUSE
)
(
FUSE
)
(
FUSE
)