Installation Guide

AutoDome 100 Series Fixed Camera Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts | en 31

Bosch Security Systems, Inc. Installation Manual F.01U.217.818 | 1.0 | 2011.04

2.9 Attach Pendant to Arm and Tighten

1. Tilt the bottom of the dome toward the pendant arm base and place the mounting hook,

located on top of the dome housing, over the recessed hinge pin of the arm.

Figure 2.15 Attach Pendant to Arm

NOTICE!

Before attaching the AutoDome Pendant, visually inspect the dome and arm connectors for

any blocked pin holes or bent pins.

1Tilt up.

2 Hook and drop.

2a Recessed Hinge Pin

2b Dome Connector

3 Rotate down to engage dome connector.

4 Tighten the two (2) mounting screws to a minimum torque of 10-12 N-m

(90-105 in.-lbs).