Installation Guide

AutoDome 100 Series Fixed Camera Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts | en 25

Bosch Security Systems, Inc. Installation Manual F.01U.217.818 | 1.0 | 2011.04

4. Connect the 5-pin, 24 VAC to Dome Plug from the Pendant Connector Harness to its

corresponding color mating connector P107 on the right side of the box.

5. Connect the BNC plug to the BNC connector from the Pendant Connector Harness and

slide its plastic cover over the connection.

6. To connect alarm inputs and relay outputs, connect the 4-pin Alarms Out, the 6-pin

Alarms In and the 7-pin Relay connectors from the Pendant Connector Harness to their

mating connectors, installed previously, to the incoming alarm wires.

7. Connect the 3-pin Power In Plug, installed previously, to its matting connector P101 on

the left side of the box.

8. If installing a Fiber Optic model attach the incoming ST fiber plug, installed previously, to

its mating connector on the Fiber Optic Module in the power supply box. Then attach the

video BNC plug to the BNC connector from the Pendant Connector Harness. Refer to

Section 5 Cable and Wire Standards, page 61 for fiber optic specifications.

Figure 2.11 Optional Fiber Optic Module

1 Transformer 5 In/Out

2 BNC to Dome 6 ST Connector (Fiber)

3In/Out 7Power In

4 From Arm Harness 8 Data In/Out

(GND)

GND TXD

RXD 

C+

C-

(

FUSE)

(

FUSE)

(

FUSE

)

24V N

HTR DOME