Technical data

In the case of an image update, the registry is automatically deleted
and the IndraControl VCH 08.1
is restarted. The IndraControl
VCH 08.1 then starts with the factory settings and all settings (touch
screen, joystick, override potentiometer, system controls, ...) must
be saved again.
The selected file can be checked for validity. "Check
file" is only active if a valid
image file has been selected.
This procedure means that the update process is started and the progress sta‐
tus is displayed. "Start update" is only active if the selected image file has been
successfully checked for validity using "Check File".
By selecting this item the registry is deleted and the IndraControl VCH 08.1 is
automatically restarted. The IndraControl VCH 08.1 then starts with the factory
settings and all settings (touch-screen, joystick and override potentiometer,
system control, ...) must be saved again.
Information on Version
You
can find the "version" register in the "Config tool", see chapter 9.5.3 "
Configuration Tool (Config Tool)" on page 66.
Fig.9-15: Display of the version information
This window displays information on the version of the WinCE-SW image and
the Config tool and IndraControl VCH 08.1 version installed at the IndraControl
VCH 08.1.
Checking the Keyboard
You will find the "Key test" register in the "Config tool", see chapter 9.5.3 "
Configuration Tool (Config Tool)" on page 66.
Project Planning Manual | Rexroth IndraControl VCH 08.1 Electric Drives
and Controls
| Bosch Rexroth AG 69/80
Software
Check File
Start Update
Clear Registry