Technical data

Fig.9-5: Service dialog
You can assign a new password in Service dialog. In addition, from this dialog
you can also reach "Config Tool" (see chapter 9.2.5 "Config Tool" on page
61) and "Rexroth settings" (see chapter 9.2.6 "Rexroth Settings" on page
61).
9.2.5 Config Tool
The config tool is started in Service dialog via the "Config tool" button, see fig.
9-5 "Service dialog" on page 61.
The following settings are available in Config tool:
● Adjustment of the brightness and contrast (however, these settings are
mainly adjusted via standard application).
● Adjustment and information display by means of the override and the hand
wheel.
● Display of the image version.
● Activation of a system update.
● Testing the keypad.
Detailed information about the individual setting dialogs can be found in chapter
9.5.3 " Configuration Tool (Config Tool)" on page 66.
9.2.6 Rexroth Settings
The Rexroth settings are started in Service dialog via the "Rexroth settings"
button, see fig. 9-5 "Service dialog" on page 61. The " Rexroth settings" dialog
is devided into two tabs ("Network settings" and "Application settings").
The "Rexroth settings" read the network data from the connection module VAC
30 out, displays this data, and allows the editing of the values, see fig. 9-6
"Network settings" on page 62.
Project Planning Manual | Rexroth IndraControl VCH 08.1 Electric Drives
and Controls
| Bosch Rexroth AG 61/80
Software