Technical data

Fig.9-2: Key assignment of the Start-up dialog
9.2.2 Start-up Application
The "Start-up application" is activated after the supply voltage has been applied
to the IndraControl VCH 08.1 and the operating system has been started.
Fig.9-3: Start-up application
In this dialog you can reach the system settings via the "Service" button or you
can start the customer application by actuating "Run". You may only use the
cursor buttons to make your selection. If you do not select an application within
five seconds, the customer application will start automatically.
Project Planning Manual | Rexroth IndraControl VCH 08.1 Electric Drives
and Controls
| Bosch Rexroth AG 59/80
Software