Technical data

Minimum current 10 mA (per contact)

Maximum current load 1,000 mA (per contact)

Utilization category DC-13 (according to IEC 60947-5-1)

Fig.4-3: Technical data of the STOP push button

4.4 Enabling Device

Nominal voltage:

24 V DC (voltage tolerance 19.2 V DC to 30 V DC according to EN 61131-2)

Nominal current:

max. 500 mA

Prescribed external fusing 2 A time-lag safety fuse

Operating cycles

switch position 2: 10

switch position 3: 5 x 10

output type solid state output

Maximum breaking current circuit 1: 1.5 A

circuit 2: 0.8 A

Maximum inductive load circuit 1: 145 mJ / 1.16 H at 24 VDC, 500 mA (comparable with DC13 according

to EN 60947-5-1)

circuit 2: 145 mJ / 1.16 H at 24 VDC, 500 mA (comparable with DC13 according

to EN 60947-5-1)

Short circuit and overload protection circuit 1: yes (integrated in the output-FET)

circuit 2: yes (through protective circuit)

Reverse voltage protection circuit 1: yes

circuit 2: yes

Actuation forces from switch 1 to 2: typically 5N

from switch 2 to 3: typically 10 N

Fig.4-4: Technical data of the enabling device

4.5 Connection Module VAC 30.2

Connections ● 1 x ethernet connection (RJ 45, 10/100 Base-T)

●

STOP push button

● Enabling device

● Power supply 24 V (see IndraControl VCH 08.1)

Prescribed external fusing 2 A time lag safety fuse

Material front panel: aluminum, metal cover: V2A

Degree of protection front panel IP 65, rear side IP 30

Fig.4-5: Technical data of the IndraControl VAC 30.2

Please

fuse cables against short circuits and cross circuits caused by the installation!

18/80 Bosch Rexroth AG | Electric Drives

and Controls

Rexroth IndraControl VCH 08.1 | Project Planning Manual

Technical Data