Operating instructions

9
B O S C H
5
“PulseSteam”
function
(Model dependent)
This appliance has a special function
for tackling difcult creases.
The “PulseSteam” function helps soften
stubborn garments like jeans or linen
faster.
When the steam release button is
activated, the steam generator will
release three powerful shots of steam
so that the steam reaches even deeper
into the fabrics.
1. Set the temperature selector (12) on
“•••”
2. Briey press the steam shot button
(14*) on the top of the handle.
or (model dependent)
Press the steam release button (13)
on the bottom of the handle two times
in quick succession (double-click).
Remarks:
▪ It is possible to stop the shots of
steam by quickly pressing the steam
button again.
▪ Some water drops may appear when
you use the “PulseSteam” function for
the rst time.
The water drops will disappear after
you have used the function for some
time.
6
Ironing without
steam
Begin ironing but without pressing the
steam release button.
7
Vertical steam
This can be used to remove creases
from hanging clothes, curtains etc.
Warning!:
▪ Never direct the steam jet at
garments that are being worn.
▪ Never aim the steam at people or
animals.
1. Set the temperature to the “•••” setting.
2. Hold the iron in an upright position
15 cm away from the garment being
steamed.
3. You can steam iron curtains and
hanging garments (jackets, suits,
coats...) by placing the iron in a
vertical position and pressing the
steam release button (13-14*).

8
“Intelligent steam”
function
(Model dependent)
This system has intelligent steam
control, which, after releasing the steam
release button (13-14*), provides a small
amount of additional steam.
The additional steam can always be
stopped by briey pressing the steam
release button once again.
9
Energy saving
“eco” button
(Model dependent)
If the “Energy saving” button (3*) is
switched on, you can save up to 25%
of the energy and 40% of the water
consumption (*), and still achieve
good results when ironing most of your
garments.
It is advisable to use the normal energy
setting only for thick and very wrinkled
fabrics.
(*) In comparison to the maximum
setting.
Note: If you work with the “Energy
saving” function, the variable
steam regulation and temperature
regulation can still be used as
recommended.