Specifications

1st Edition/Revision 6 (2/2/04)

WFMC Service Tips

Test Program (1B): Starting

WFMC6400 Test Program

The WFMC6400 washer test programs self-diagnose problems

, including listing the last 8 fault

codes from the control module

& the last 16 fault codes from the motor control. The tests are easy

to use, speeding up and simplifying diagnosing washer issues.

Entering & using WFMC6400 test programs:

• To reset, rotate cycle selector knob to Off position.

• To enter test program

, push and hold Menu and Select buttons at the same time, then rotate cycle

selector knob ccw to Permanent Press Cold position. Hold Menu and Select buttons until P1:

Errors shows in display.

• To select tests

, push Menu button (to scroll through tests) until desired test shows in display (P1 -

P17) - Start/Pause light will flash.

• To start tests

, push Start/Pause button while its light is flashing -- light stays lit when test has

started. To end tests

, push Menu button.

• To exit test program, rotate cycle selector knob to Off position.

NOTE: Door locks

for all water fill and

drain tests.

HINT: If

Start/Pause light

doesn’t come on for

some tests, door is

open. Turn off

washer, then close

door.

WFMC6400UC

P1:ERRORS