en-us Use and care manual Dryer WTB86200UC @ BOSCH
Welcome to Your New Dryer! Congratulations on your selection of a new Bosch dryer for your laundry needs. We are confident you will enjoythe superior performance and reliability. Please do not hesitate to contact our Customer Service department if you have any questions or comments with your new dryer. Thank you for choosing Bosch. Visit our web site at www.bosch-home.com for more information and to view a selection of our products.
Table of contents Important information ................................................... 4 Purchase information ........................................................... 4 Customer service ................................................................. 4 Your dryer is intended for ............................................. Loading the laundry .......................................................... 23 Starting the program ........................................................
Important information Purchase Customer information Please take a moment to record the following basic information about the purchase of your new Bosch dryer. This information will be helpful in the event you need to contact Customer Service or would like to order accessories or replacement parts for your dryer. service Your dryer does not require any special care other than the maintenance and care mentioned in this manual.
Your dryer is intended for Only for household environment. use and in a non-commercial o Household use only for drying washable textiles. o The dryer can be operated by people with reduced physical, sensory or mental capabilities, and by people with little experience or knowledge if they are supervised or were trained by a responsible person. o Recommended operating conditions: Ambient temperature: 41-95°F / 5-35°C Relative humidity: under 95% o Installation by qualified installers.
A IMPORTANT SAFETY INSTRUCTIONS READ AND SAVE THESE INSTRUCTIONS WARNING When properly cared for, your new appliance has been designed to be safe and reliable. Read all instructions carefully before use. These precautions will reduce the risk of burns, electric shock, fire, and injury to persons. When using laundry appliances, basic safety precautions must be followed, including those in the following pages. Examine the appliance after unpacking transport damage, do not plug it in. it.
IMPORTANT A SAFETY INSTRUCTIONS READ AND SAVE THESE INSTRUCTIONS o Keep all laundry aids (including detergents, bleach, fabric softener, etc.) out of the reach of children. WARNING WARNINGS FOR CHILDREN o Do not allow children to play on or in the appliance. Close supervision of children is necessary when the appliance is used near children. o Make sure to utilize all child lock/safety features of your appliance, and be sure to turn the appliance Off when not in use.
Use optimum load! Utilize the maximum amount of laundry for the appropriate cycle. However, do not exceed loads. Clean filter! Clean the lint filter before or after each drying process. ---> Cleaning the tint filter; Page 25 Dimensions and clearances Installation Air inlet on the dryer! Do not cover or allow any articles/items air inlet on the front of the dryer. to restrict the Energy-saving mode! The display panel lighting goes out after a few minutes and Start/Pause flashes.
Closet: Stand alone (shown) or Side by Side Under counter (Preferred) A C // // Front of the appliance fully open. No doors or coverings. Minimum opening Label Dimension dimensions A 23.8 in. 60.5 cm Metric B 23.8 in. 60.5 cm Inches cm C 33.5 in. 85 cm U.S. A Both Sides 0.6 1.5 B C Top Rear 6.3 2.5 16 6.2 D Front 2.4 6 Under counter (Less Desirable) E & F are minimum area size! E Top Vent 63 sq. 404 sq. F Bottom Vent 63 sq. 404 sq.
Installation Instructions SAVE THESE INSTRUCTIONS the dryer Unpacking the appliance Introduction Read these installation instructions completely and carefully before starting to install your new dryer. The information contained can save you time and effort and will help to ensure optimum performance of your new dryer. Be sure to observe all warnings and cautions.
Parts provided with your dryer Back side of the dryer drain hose pack contents: o (2) plastic ties for securing drain hose o plastic connector o summary of drain hose installation instructions literature pack contents: o User manual o Warranty NOTICE: If any parts are missing please notify your dealer immediately. Accessories for your appliance Pedestal The dryer can be mounted on a special pedestal for easier loading and unloading.
6.Connecttheoutletendof thedrainhoseto a standpipeor otherdraininlet.Examplesareshown below. Fq CAUTION o o o o APPLIANCE DAMAGE COULD OCCUR IF DRAIN WATER FLOWS BACK INTO THE APPLIANCE In all drain conditions, scenarios, or connections you must ensure: The drain water from the hose is free flowing and not obstructed allowing adequate water flow. Drain opening is not sealed in any way and ventilated enough not to cause a back siphon.
@ @ @ Use only a 4-wire/conductor power cord when the appliance is installed in a mobile home, recreational vehicle, in a new branch-circuit installations or where the local codes do not permit grounding through the neutral. If installedin an upperfloorof a multi-story building, the dryershouldbeinstalledon a drainedfloorto preventwaterdamageto lowerfloorsinthe eventof a leak. Electrical Connections Replacement power cords are available through our Customer Service department.
1. Unplugthe currentpowercord beingusedfromthe outlet/receptacle. 2.Todisconnectand/orreconnecta newpowercord youmustremovethetop coverofthe applianceas shownbelow. A.Removethe twoT20torxheadscrews. B.Pushthetop covertowardthe rearof theappliance andlift up. terminalends)comein contactwithconnectionbox enclosure. NOTICE: Use only open-end spade lugs. 9. Ensure the terminal ends are long enough and are formed (bent) so they will align with the terminal block fastening locations (screw holes). 10.
To adjust the dryer feet: 1. Install the dryer on a level and solid surface, preferably in a corner of a room. Preparing step to transport the dryer - step by 1. Rotate the program selector to Off. 2. If the floor is uneven (or not level) adjust the dryer feet as required to level the dryer. Do not place anything under the dryer feet to help level the dryer. 2. Pull out power supply plug. 3. Extend the dryer feet no more than is necessary.
Getting to know your appliance Control panel Start Pause Perm Press ExtraDry Off Cotton Extra Dry PermPressDry Cotton Dry , HeavyDuty Cotton Damp Sanitary DelicaLes Jeans Timedprogram 40 hot Quick Dry Air fluff!No heat TimeDry Woolens I-T-1 Time Dry, Dry Level, Finished in Changing the program settings. Indicator lamp lights up if the setting is active. Low Heat, Wrinkle Block, Signal Additional option settings. Indicator lamp lights up if the setting is active.
Display area Drying cycle status sequence [-_ Childproof Time Dry -_ and Dry Level -",o: -+indicators lock indicator [---6--1 Indicator lamps for additional option settings: Low Heat, Wrinkle Block and Signal Cleaning required indicator [-_ [-7-] Check drain indicator 4 Digit Display: o Finished in time adjustable in 1 h (h=hour) steps to 24h o program duration 3:00 Laundry Preparing the laundry NOTICE: Damage to the appliance/fabrics Foreign objects (e.g.
o Donotdry woolensin thedryer.Theymay,however, berefreshedby usingtheWoolensprogram. o Starchedlaundryis notalwayssuitablefor dryer. Starchleavesbehinda coatingthatreducesthedrying effect. o Whenwashinglaundrythatis to be tumble-dried afterwards,usethe correctamountoffabricsoftener as specifiedin the manufacturer's instructions. o Forpre-dried,multi-layered fabricsor small,individual itemsof laundry,usetheTimeprogram. --->Program selection table; Page 18 Also suitable for subsequent drying.
_ Program settings At the factory initial settings are pre-set for all cycles. You can change some program settings as follows. After setting the Dry Level for a program, it is also retained for other programs, until it is changed again. Finished in Time Dry Available only for Time programs, ---> Program selection table; Page 18 can be selected from minimum 20 minutes to maximum 3 hours, in 10-minute steps.
Operating Instructions • , WARNING RISK OF FIRE, ELECTRIC SHOCK, OR INJURY To reduce the risk of fire, electric shock, or injury to persons, read the Important Safety Instructions and Operating Instructions before operating this appliance. Your new dryer Control panel, display area, program selector Drum with interior light (depending on model) The light up after the door is opened and after the program starts, and switches off automatically.
[-_ Lint filter Air inlet [--6-] Open the maintenance flap Close the maintenance flap Heat exchanger _. WARNING 4. Check the dryer for visible damage. If damage found contact your dealer. BEFORE INSTALLING OR USING YOUR DRYER 5. Wipe the inside of the drum with a damp cloth. Read and follow all installation and operating instructions. 6. Check heating system. ---> Check heating system; Page 15 Check the machine.
Inthe displayarea,the cycledurationforthe selected programappears. Program selection For optimum drying results your dryer offers several program groups and additional options. Select the required drying program from the program table according to the examples. ---> Program selection table; Page 18 Automatic programs There are automatic programs for different types of textiles (regular/cotton, permanent press). Time programs Time programs run at specific temperatures.
Loading • , the laundry Load the laundry WARNING RISK OF EXPLOSION Do not dry the laundry that has ever been in contact with solvents, oil, wax, grease or paint (e.g. hair styling products, nail varnish remover, stain remover, cleaning solvent, etc.). 1. Check lint filter. Place laundry in the empty drum. Put each piece of laundry into machine separately. For best results the laundry to be dried must be sorted according to type of laundry and desired degree of drying.
o If Checkdrain indicatorlightsup,checkthedrain hoseanditsconnection. --->Maintenance of drain hose; Page 27 3. If required, select Low Heat by pressing the button. ---> Additional options; Page 19 4. If required, select Wrinkle Block by pressing the button. ---> Additional options; Page 19 Tip: The estimated remaining time will be updated. Indicator of program sequence The dryer uses an electronic control system. A moisture sensor continuously checks the moisture in the laundry.
_, _ ___,_: ,_;:_ __ Cleaning and care _. 2. Open the door. WARNING =_.. RISK OF EXPLOSION Never use solvents or highly flammable cleaning. • , liquids for CAUTION Incorrect cleaning may damage the dryer. Do not spray with a water jet. Do not use scouring agents or all-purpose cleaners. Do not use steam cleaners. Cleaning Wipe water Wipe damp the housing 3. Pull out filter. and control panel the housing and fascia with a soft cloth and soapy only.
6.Closethefilterandre-insertit. 3. Unlockthe maintanance flap andopenit completely. 7,Closethedoor. 4, Turn both locking levers towards each other. NOTICE: The filter should be rinsed once a year under warm running water. 5, Pull out the heat exchanger cap. 6, Remove the heat exchanger. The filter must be dried thoroughly replaced. Cleaning NOTICE: Do not damage the heat exchanger! Clean with warm water only.
8. Removeanyflufffromthe sealson thedryerandheat exchanger. 9.Allowthecap andthe heatexchangerto dryfully. 10.Firstinsertthe heatexchanger,thenthecap. 11.Turnbackbothlockinglevers. NOTICE: Use white vinegar only! Clean the moisture sensors once a month. Cleaning the lint filter area Over time, fluff from the drying process collects in the lint filter area. 12.Closethe maintanance flapuntilit locksintoposition. 13. Look in the Troubleshooting table also to reset the maintenance indication.
Troubleshooting Introduction NOTICE: Before doing maintenance work or trying to rectify a problem by yourself, rotate the program selector to Off. Before calling the customer service, check whether you can rectify the fault yourself by means of the following table. If a fault cannot be rectified or a repair is required: 1. Set program selector to the Off. The program will not continue running when the power supply has been restored. Desired program must be selected again and start button pressed. _.
Problem Possible cause(s) Solution(s) The Check drain indicator light up. Water has not drained completely. Drain hose is blocked. Check drain hose. ---> Maintenance of drain hose; Page 27 Check drain hose connection conditions. Drain hose is leaking: is not screwed on the tight at both ends, or rubber not placed in hose. Check the drain hose, be sure that it is on the dryer securely with the clamp in place; may need to replace the drain hose if leaking continues. Dryer is not leveled.
Problem Oneor moreindicator lightsareflashing. Possible cause(s) Solution(s) Lint filter or/and heat exchanger is dirty. Installation conditions are not fine. Clean lint filter or/and heat exchanger (see solution of the problem(s) in this table above). Check the installation conditions. Electrical Connections; Page 13 Fault in program sequence or malfunction. Switch off the dryer, allow it to cool down, switch back on and restart the program. Powerfailure.
the nearestauthorizedserviceprovider,butyouwould stillbe fullyliableandresponsiblefor anytraveltimeor otherspecialchargesbythe servicecompany,assuming theyagreeto makethe servicecall. Extended Limited Warranty: LENGTH OF EXTENDED LIMITED WARRANTY 2 year Limited Warranty from date of Purchase.
@ BOSCH IIIIIII IIIII IIIII IIIII IIIII IHIIIII IIIII IIIII IIIII IIII IIII 9000866559 9308 1901 Main Street, Suite 600 • Irvine, CA 92614 ° 1-800-944-2904 www.bosch-home.
