Data Sheet

Fire Alarm Systems | SOLO851 Complete SOLO Kit
The SOLO851 Detector Service Kit contains the basic SOLO
equipment required to test smoke and heat detectors at
heights up to 23 ft (7 m). Also used to remove and replace
detectors.
Note Smoke testing requires SOLOAEROSOLA4
Smoke Aerosol which is not supplied.
Parts Included
Quant. Component
1 SOLO100 Telescopic Extension Pole
1 SOLO101 Fixed Extension Pole
1 SOLO200 Detector Removal Tool
1 SOLO330 Smoke Detector Tester
1 SOLO461 Heat Detector Tester
1 SOLO610 Test Equipment Bag
2 SOLO720 Batteries (for heat detector tester)
1 SOLO725 Battery Charger
Technical Specifications
Environmental Considerations
Relative Humidity: 0 to 85%, non-condensing
Temperature
Operating: +40°F to +115°F (+4°C to +46°C)
Storage: +15°F to +120°F (-9°C to +49°C)
Mechanical Properties
Detector Height: Up to 22 ft (6.7 m) high
Detector Size Range
1
:
Diameters up to 3.9 in. (99 mm)
Weight: 1 lb 4 oz (567 g)
Working Angle: 0° to >90°
1
Only the sensing chamber needs to be sealed within the tester cup.
Trademarks
Trademark names are used throughout this document. In
most cases, these designations are claimed as trademarks
or registered trademarks in one or more countries by their
respective owners. Rather than placing a trademark symbol
in every occurrence of a trademark name, Bosch Security
Systems, Inc. uses the names only in an editorial fashion
and to the benefit of the trademark owner with no intention
of infringing the trademark.
SOLO is a trademark of No Climb Products, Ltd.
SOLO851 Complete SOLO Kit
▶
Woven polyester bag with special compartments to
hold a full range of products; separate pole bag
included
▶
Needed equipment stays organized and protected
▶
Easy to transport
www.boschsecurity.com