Instruction Manual

Operating the Dishwasher en-us
39
Note: Your dishwasher is protected
against unintentional operation. If the
appliance door remains open for
more than 4 seconds after pressing
the Start button, the operation will be
paused. Press the Start button again
and close the appliance door.
Cancel a cycle (Reset)
1. Open the door and press and
hold Start button P for
approximately 3 seconds until the
display reads ‹:‹‚, then close
door again.
2. Wait about 1 minute while the
dishwasher drains.
3. Open the door and press the
On/Off button (.
Changing the wash cycle
When the Start button ( has been
pressed, the wash cycle cannot be
changed. The only way a wash cycle
can be changed is by terminating the
wash cycle (Reset).
Intensive drying
The final rinse uses a higher
temperature which improves the
drying result. The cycle time may
increase slightly. (Caution if utensils
are delicate!)
This feature has two settings:
To change the setting:
1. Open the door.
2. Press On/Off button (.
3. Hold down function key # and
press Start button P until the
display 8 shows •:‹x or š:‹x
(x can be any number).
4. Release both buttons.
The indicator of function key #
flashes and the display 8
shows the factory set value.
5. Press function key # until the
display 8 shows the factory set
value š:‹‹.
6. Press function key 3 to switch
the feature on š:‹‚ or off š:‹‹.
7. Press Start button P to save
setting.
š:‹‹ Off
š:‹‚ On