Instruction Manual

en-us Operating the Dishwasher
38
Auto power off
This setting determines the length of
time the control panel stays
illuminated after the cycle is
complete.
To save energy the recommended
setting is ˜:‹‚.
This setting can be adjusted from
˜:‹‹ to ˜:‹ƒ.
To change the setting:
1. Open the door.
2. Press On/Off button (.
3. Hold down function key # and
press Start button P until the
display 8 shows •:‹x or š:‹x
(x can be any number).
4. Release both buttons.
The indicator of function key #
flashes and the display 8
shows the factory set value.
5. Press function key # until the
display 8 indicates ˜:‹x.
6. Press function key 3 until the
display corresponds with your
requirements.
7. Press Start button P.
Switching off the appliance
Short time after the end of the wash
cycle:
1. Open the door.
2. Switch off On/Off button (.
3. Turn off water supply.
4. Remove the utensils when they
have cooled down.
9 WARNING
RISK OF INJURY!
To avoid risk of injury, always
use caution when opening the
door during or following a wash
cycle as hot water or steam
may escape. Do not fully open
the door until water noises have
stopped and steam has
subsided.
Interrupting the wash cycle
9 CAUTION
Expansion (overpressure) may
cause the appliance door to
open and/or water to escape! If
the door was opened on an
appliance which has a hot water
connection or is heated, always
leave the door ajar for several
minutes and then close.
1. Open the door.
2. Switch off On/Off switch (.
The LED’s go out. The wash cycle
is saved.
3. To continue the wash cycle,
switch on the On/Off switch (
again.
4. Close the door.
˜:‹‹ dishwasher does not turn off
automatically
˜:‹‚ dishwasher turns off
automatically after 1 minute
˜:‹ƒ dishwasher turns off
automatically after
120 minutes (2 hours)