Instruction Manual

en-us Water softening system / special salt
14
Adjusting the water softener settings
Adjusting the water
softening system
The amount of salt dispensed can be
set from •:‹‹ to •:‹ˆ. Salt is not
required at the set value •:‹‹.
Set the softening system as follows:
1. Ask your local water utility
company for the water hardness
value of your tap water or use test
strip.
2. Required setting can be found in
the water hardness table.
3. Press On/Off button (.
4. Hold down function key # and
press Start button P until the
display 8 indicates •:‹x (x can
be any number).
5. Release both buttons.
The indicator of function key #
flashes and the display 8
indicates •:‹‹. Press function key
3 to select the desired setting.
6. Press Start button P to save
the setting.
The chosen setting has now been
stored.
Using the test strip included with
your dishwasher
(Purchased test strips may have a
different scale)
Water
softener
setting
Add salt to
salt
dispenser
Water hardness conversion chart
(only necessary if you purchase a
different test strip)
ppm gpg/°dH
•:‹‹ No 0 116 0 6
•:‹‚ Yes 117 152 7 8
•:‹ƒ Yes 153 188 9 10
•:‹„ Yes 189 223 11 13
•:‹… Yes 224 294 14 17
•:‹† Yes 295 383 18 22
•:‹‡ Yes 384 544 23 31
•:‹ˆ Yes 545 890 32 52