Design Guide

1–800–944–2904 | bosch-home.com/us
Benchmark
®
| Dishwashers | 157
Benchmark
®
Dishwashers
Dishwashers — Benchmark
®
Note: Refer to installation template for mounting hardware locations
** measured from the bottom edge of the countertop panel thickness
recommended 3/4” (20 mm).
*** 24” (610 mm) wide panel may be used
depending on cabinet design
This dishwasher can accept custom door panel weights ranging
from 7 to 24 lbs; however, the dishwasher comes from the factory
ready for custom panel door weights from 11 to 18 lbs.
If you plan on using a door panel that is not 11 to 18 lbs.
please contact customer service at [phone].
Custom Panel – Dimensions and Cutout
Included Parts & Accessories
Pre-connected
drain hose
Pre-connected
AquaStop
®
inlet hose
Toe-kick
Power cord with
junction box
Included:
Example of Hardwire Installation
Ø 2
1
/2"
(63.5 mm)
7"
(178 mm)
Note: Cutout
required on left or right
cabinet wall, depending on
location of water inlet, drain
and electrical connection
Power cord
with junction
box included
2
1
/2"
(63.5 mm)
Pd
Example of Electrical Receptacle Installation
Plumbing
Ø 2
1
/2"
(63.5 mm)
7"
(178 mm)
Note: Cutout
required on left or right
cabinet wall, depending on
location of water inlet, drain
and electrical connection
Power cord
with junction
box included
2
1
/2"
(63.5 mm)
Pd
Water and Electrical Locations
Non-metallic tie
min 20" (50 mm) max 43" (110 mm) min 20" (50 mm) max 43" (110 mm)
Non-metallic tie
Remove
plug
Note: Plumbing installations will vary - refer to local codes.
Drain hose included is 88 5/8" (225 cm) and can be
extended to a maximum of 165 3/8" (420 cm).
Always use the approved drain hose extension kit
(SGZ1010UC).
Ensure a portion of the drain hose is raised between min.
20" (50 cm) and max. 43" (110 cm) above the cabinet floor.
Dimensions and Cutout