Use and Care Guide

17
Delay Start
You can delay the start of the cycle in one hour increments up to 24 hours.
To set delay start:
1 Press the [On/Off] button.
2 Press the [+] button until the display jumps to “h:01”.
3 Press the [+] or [-] button until the displayed time corresponds with your requirements.
h:01 = 1 hour delay
h:24 = 24 hour delay
4 Press [Start] to activate delay start.
To cancel delay start:
1 Press the [+] or [-] button until “h:00” is indicated on the digital display.
2 Press and hold [Start] for 3 seconds to cancel the cycle. You may now start a new cycle.
Cycle Completion Signal
1 Open the door and press the [On/Off] button.
2 Hold down the “A” button (see page 15) and press [Start] until the display indicates “d:00”.
Release both buttons.
3 Press the “A” button until the display shows “b:02”.
4
Press the “C” button to increase or decrease the tone “b:00” = OFF and “b:03” = LOUDEST and press
[Start] to save setting and close the door.
Infolight®
An LED illuminates the floor to indicate the unit is running. If the appliance is installed at eye-level, the
LED is not visible.
To change the setting:
1 Open the door and press the [On/Off] button.
2 Hold down the “A” button (see page 15) and press [Start] until the display indicates “d:00”.
3 Release both buttons.
4 Press the “A” button until the display shows “1:01”.
5 Press the “C” button to switch between “1:01” = ON and “1:00” = OFF and press [Start] to save.