Interactive User Manual
Table Of Contents
- Table of contents
- en-us Operating instructions
- ( Safety Definitions 5
- ( IMPORTANT SAFETY INSTRUCTIONS 6
- ƒ Causes of Damage 9
- * Getting Started 10
- , Rinse Aid 13
- - Loading the Dishwasher 15
- . Detergent 27
- / Dishwasher Cycles 29
- 0 Dishwasher Cycle Options 30
- 1 Operating the Dishwasher 34
- 2 Care and Maintenance 39
- 3 Troubleshooting 44
- 4 Customer Service 49
- ‡ Statement of Limited Product Warranty 50
- ( Safety Definitions
- en-us Operating instructions
- ( IMPORTANT SAFETY INSTRUCTIONS
- IMPORTANT SAFETY INSTRUCTIONS
- READ AND SAVE THESE INSTRUCTIONS
- To reduce the risk of fire, electrical shock, or serious injury, observe the following:
- 9 WARNING
- 9 WARNING
- 9 WARNING
- 9 WARNING
- 9 WARNING
- 9 WARNING
- 9 CAUTION
- ƒ Causes of Damage
- * Getting Started
- , Rinse Aid
- Rinse Aid
- Note:
- Adding rinse aid
- NOTICE
- 1. Open the rinse aid dispenser 92 by pressing on the latch of the lid and pull it open.
- 2. Add liquid rinse aid to the dispenser 92 until it is full. Do not overfill. Avoid spilling into air vent hole.
- 3. Close the lid. Lid must be fully closed until it clicks in order to seal.
- 4. Wipe up any excess rinse aid that may have puddled when the dispenser reservoir is full.
- Tip:
- NOTICE
- Setting the amount of rinse aid used
- Setting
- Amount
- 1. Open the door.
- 2. Press the On/Off button (.
- 3. Hold down the function key # and press the Start button P until the display 8 indicates š:‹x (x can be any number). Release both buttons.
- 4. Press the function key # until the display 8 shows §:‹†.
- 5. Press the function key 3 to select the desired setting.
- 6. Press the Start button P to save the setting.
- Turning off rinse aid indicator
- - Loading the Dishwasher
- 9.4 in (24 cm)
- 12.6 in (32 cm)
- 10.4 in (26.5 cm)
- 11.8 in (30 cm)
- 11.4 in (29 cm)
- 10.6 in (27 cm)
- 7 in (18 cm)
- 12.6 in (32 cm)
- 8 in (20.5 cm)
- 11.8 in (30 cm)
- 9 in (23 cm)
- 10.6 in (27 cm)
- RackMatic®
- Rack accessories
- Removing/Installing third rack
- Removing third rack 1*
- Installing third rack 1*
- 1. Pull out third rack rails all the way (1).
- 2. Insert third rack at an angle. Make sure that the stopper hooks of both rails slide in between the holding hooks and the lower rollers of the third rack (2).
- 3. Slide third rack in and lift the upper rollers over the front stopper hooks of both rails (3).
- 4. Push in third rack (4).
- Removing/Installing upper rack with Rackmatic®
- Removing upper rack 12
- Installing upper rack 12
- 1. Pull out upper rack rails all the way (1).
- 2. Insert upper rack at an angle. Make sure that the stopper hooks of both rails slide in between the upper and lower rollers on the rear side of the rack (2).
- 3. Slide upper rack in and lift the upper rollers over the front stopper hooks of both rails (3).
- 4. Push in upper rack (4).
- . Detergent
- / Dishwasher Cycles
- The Energy Guide label was based on the Normal soil sensing cycle as follows: The unit was tested without any rinse aid (liquid) in the rinse aid dispenser 92. A single dose of detergent was inserted into the detergent dispenser 9:, with no detergent...
- Only sanitizing cycles have been designed to meet the requirements of Section 6 of the NSF/ANSI Standard for Residential Equipment for soil removal and sanitization efficacy. There is no intention, either directly or indirectly, to imply that all cyc...
- 1 Operating the Dishwasher
- Operating the Dishwasher
- Note:
- 9 WARNING
- Protection against unintentional operation
- AquaSensor
- Switching the appliance on
- Time display
- Delay Start
- Wash cycle end
- To change the signal volume:
- 1. Open the door.
- 2. Press the On/Off button (.
- 3. Hold down function key # and press Start button P until the display 8 indicates š:‹x (x can be any number). Release both buttons.
- 4. Press function key # until the display shows ›:‹ƒ.
- 5. Press function key 3. Each time the button is pressed the set value increases by one level; when it reaches the value ›:‹„, the display jumps back to ›:‹‹ (off).
- 6. Press Start button P to save the setting.
- To change the signal volume:
- Auto power off
- To change the setting:
- 1. Press the On/Off button (.
- 2. Hold down the function key # and press the Start button P until the display 8 indicates š:‹x (x can be any number).
- 3. Release both buttons.
- 4. Press the function key # until the display 8 indicates ˜:‹x.
- 5. Press the function key 3 until the display corresponds with your requirements.
- 6. Press the Start button P.
- To change the setting:
- Switching off the appliance
- Interrupting the wash cycle
- 9 CAUTION
- Terminating the wash cycle (Reset)
- Changing the wash cycle
- InfoLight® *
- To change the setting:
- 1. Open the door.
- 2. Press the On/Off button (.
- 3. Hold down function key # and press Start button P until the display 8 indicates š:‹x (x can be any number). Release both buttons.
- 4. Press function key # until the display shows ‚:‹‚.
- 5. Press the function key 3 to switch the InfoLight® feature on ‚:‹‚ or off ‚:‹‹.
- 6. Press Start button P to save the setting.
- To change the setting:
- TimeLight® (Optical display while the wash cycle is running) *
- All time remaining displays
- To change the setting:
- 1. Open the door.
- 2. Press On/Off button (.
- 3. Hold down function key # and press Start button P until the display 8 shows •:‹x or š:‹x (x can be any number).
- 4. Release both buttons. The light above function key # flashes and the display 8 shows the factory set value.
- 5. Press function key # until the display 8 shows the factory set value †:‹‚.
- 6. Press function key 3 to switch between †:‹‹ and †:‹‚.
- 7. Press Start button P to save setting.
- Intensive drying
- 1. Open the door.
- 2. Press the On/Off button (.
- 3. Hold down function key # and press Start button P until the display 8 indicates š:x (x can be any number).
- 4. Release both buttons.
- 5. Press function key # until the display 8 indicates the factory set value š:‹‹.
- 6. Press function key 3 to switch the Extra dry feature on š:‹‚ or off š:‹‹.
- 7. Press Start button P to save setting.
- 2 Care and Maintenance
- 3 Troubleshooting
- --------
- 1 Operating the Dishwasher
Statement of Limited Product Warranty en-us
51
■ BSH will repair or replace the
stainless steel door if the door
should rust through (excludes
labor charges).
Repair/Replace as Your
Exclusive Remedy
During this warranty period, Bosch or
one of its authorized service
providers will repair your Product
without charge to you (subject to
certain limitations stated herein) if
your Product proves to have been
manufactured with a defect in
materials or workmanship. If
reasonable attempts to repair the
Product have been made without
success, then Bosch will replace
your Product (upgraded models may
be available to you, in Bosch’s sole
discretion, for an additional charge).
Nothing in this warranty requires
damaged or defective parts to be
replaced with parts of a different type
or design than the original part. All
removed parts and components shall
become the property of Bosch at its
sole option. All replaced and/or
repaired parts shall assume the
identity of the original part for
purposes of this warranty and this
warranty shall not be extended with
respect to such parts. Bosch's sole
liability and responsibility hereunder
is to repair manufacturer-defective
Product only, using a
Bosch-authorized service provider
during normal business hours. For
safety and property damage
concerns, Bosch highly recommends
that you do not attempt to repair the
Product yourself, or use a
non-authorized service provider;
Bosch will have no responsibility or
liability for repairs or work performed
by a non-authorized service provider.
Authorized service providers are
those persons or companies that
have been specially trained on Bosch
products, and who possess, in
Bosch's opinion, a superior
reputation for customer service and
technical ability (note that they are
independent entities and are not
agents, partners, affiliates or
representatives of Bosch).
Notwithstanding the foregoing, Bosch
will not incur any liability, or have
responsibility, for the Product if it is
located in a remote area (more than
100 miles from an authorized service
provider) or is reasonably
inaccessible, hazardous, threatening,
or treacherous locale, surroundings,
or environment; in any such event, if
you request, Bosch would still pay for
labor and parts and ship the parts to
the nearest authorized service
provider, but you would still be fully
liable and responsible for any travel
time or other special charges by the
service company, assuming they
agree to make the service call.
Out of Warranty Product
Bosch is under no obligation, at law
or otherwise, to provide you with any
concessions, including repairs,
prorates, or Product replacement,
once this warranty has expired.
Warranty Exclusions
The warranty coverage described
herein excludes all defects or
damage that are not the direct fault
of Bosch, including without limitation,
one or more of the following:
■ Use of the Product in anything
other than its normal, customary
and intended manner (including
without limitation, any form of
commercial use, use or storage of
an indoor product outdoors, use
of the Product in conjunction with
air or water-going vessels).










