Installation Guide

3ODFHWKHDVVHPEOHGVWUDLQUHOLHI
plate back into the junction box and
UHDWWDFKWKHVFUHZ0DNHVXUHWKH
tab on the right side of the strain
relief plate is outside the junction
box as you slide it into place.
Do Not Over-tighten or
Remove Terminal Screws
14
Note: Do not loosen or remove
terminal screws! Damage may
occur. Bend the wires so the
exposed leads can reach the
appropriate contacts. Insert the
black (hot) wire into the left opening
RQWKHWHUPLQDOVWULSPDUNHG³/´WKH
white (neutral) wire in the middle
opening of the terminal strip marked
³1´DQGWKHEDUHFRSSHURUJUHHQ
(ground) wire into the right opening
RIWKHWHUPLQDOVWULSPDUNHG³*´
Hand tighten only. Do not use
power tools.
Do Not Over-tighten or
Remove Terminal Screws
15
0DNHVXUHWKDWWKHH[SRVHG
QRQLQVXODWHGSRUWLRQRIHDFK
stripped wire shows above
and below the terminal screw.
6HFXUHO\WLJKWHQWKHWHUPLQDO
screws, but do not over-tighten
or damage may occur.
16
13