Instruction Manual

en-us Operating the Dishwasher
32
2. Hold down the function key #
and press the Start button P
until the display 8 indicates
š:‹x (x can be any number).
3. Release both buttons.
4. Press the function key # until
the display 8 indicates ˜:‹x.
5. Press the function key 3 until
the display corresponds with your
requirements.
6. Press the Start button P.
Switching off the appliance
Short time after the end of the wash
cycle:
1. Open the door.
2. Switch off On/Off button (.
3. Turn off water supply.
4. Remove the utensils when they
have cooled down.
9 WARNING
RISK OF INJURY!
To avoid risk of injury, always
use caution when opening the
door during or following a wash
cycle as hot water or steam
may escape. Do not fully open
the door until water noises have
stopped and steam has
subsided.
Interrupting the wash cycle
9 CAUTION
Expansion (overpressure) may
cause the appliance door to
open and/or water to escape! If
the door was opened on an
appliance which has a hot water
connection or is heated, always
leave the door ajar for several
minutes and then close.
1. Open the door.
2. Switch off On/Off switch (.
The LED’s go out. The wash cycle
is saved.
3. To continue the wash cycle,
switch on the On/Off switch (
again.
4. Close the door.
Note: Your dishwasher is protected
against unintentional operation. If the
appliance door remains open for
more than 4 seconds after pressing
the Start button, the operation will be
paused. Press the Start button again
and close the appliance door.
Terminating the wash cycle
(Reset)
Ter minating the wa s h cycl e 1. Press and hold Start button P
for approximately 3 seconds until
the display reads ‹:‹‚.
2. Wait about 1 minute while the
dishwasher drains.
3. Press On/Off button (.
You may now power the dishwasher
back on and begin a new cycle if
desired.
Changing the wash cycle
When the Start button ( has been
pressed, the wash cycle cannot be
changed. The only way a wash cycle
can be changed is by terminating the
wash cycle (Reset).