User manual

DCN Next Generation Open Interface Release 2.0 Simultaneous Interpretation
en | 125
Bosch Security Systems B.V. | 2005 January | 9922 141 70542
Event IN_C_CCU_CON
FIG
IN_C_CHAN_STA
TUS
IN_C_FLASHI
NG_MIC_ON
IN_C_FLOO
R_DISTRIB
UTION
IN_C_LANGUA
GE_LIST
IN_C_SPEAKS
LOWLY_SIGN
IN_C_HELP_SI
GN
Select B as active out channel
4
- X/- - - -
Start install mode
4
- X/- - - -
Stop install mode
5
X/- X X/- - - X/- X/-
Select floor signal as incoming channel
4
- X/- - - -
Select relay signal as incoming channel
4
- X/- - - -
Select autorelay signal as incoming channel
4
- X/- - - -
4
This action only leads to the shown notification if the microphone of the interpreter desk is turned on when the action is performed. If the microphone is off, performing the
action will not lead to any update notifications.
5
If the CCU controls the IN application (i.e. no remote controller connected), the interpreter desks have a full installation menu. Therefore more settings than present in the
IN_C_CHAN_STATUS notification can be changed. Due to this reason the IN_C_CCU_CONFIG, IN_C_FLASHING_MIC_ON. IN_C_SPEAKSLOWLY_SIGN and
IN_C_HELP_SIGN update notification are also sent, but only when there is no remote controller.