Technical data

Configuration
Programming and Operating the AMAX System
The AMAX system can be programmed and operated over menus by using keypads and/or the
A-Link Plus remote programming software on a PC via the USB interface.
After all modules and devices have been installed, the AMAX panel indicates the system status
by the LED status indicator on the system main board. A slow flashing in red (repeating on
and off with an interval of 1 second) indicates normal system operation.
The AMAX panel begins charging the battery. The green MAINS indicator on the keypad
indicates that the power supply is switched on and the keypad beeps.
4 Press any key on the keypad.
The keypad stops beeping and you are prompted to enter a code.
The AMAX system provides two types of access codes:
– Installer Code: [1234]
– User Code: [2580]
Option: Changing Menu Language
If necessary, you may now change the menu language. If not, please go to section Accessing
the Menus, page 10.
4 Enter the Installer Code [1234] + [58] or the User Code [2580] + [58] and press the [#]
key.
The available menu languages are displayed (e.g. 01-EN for English).
1. Enter the digit for the desired language on the keypad (e.g. 1 for English).
2. Press the [#] key.
Accessing the Menus
Accessing the Installer Menu
4 Enter the Installer Code [1234].
The system displays [958] PROGR. MODE [-EXIT].
4 Enter [958] + press the [#] key.
You have now access to the PROGRAMMING MODE for programming the AMAX system.
The STAY and AWAY indicators flash to indicate the programming mode.
Accessing the User Menu
4 Enter the User Code [2580].
The system displays [▼/▲] USER MENU *STAY #AWAY [-] INFO.
You have now access to the USER MENU for operating the AMAX system.
Menu Navigation
This section gives an overview of how to navigate through the menu on the keypad.
Selecting a Menu
4 Select the menu and operate according to the menu prompt.
Press the [▼] or [▲] keys to navigate to the desired menu.
Press the [#] key to enter a menu.
Exiting a Menu
4 Press the [–] key to get back to the menu.
Or
4 Press and hold the [–] key for 3 seconds to end the input state and get back to the
previous menu.
5
5.1
5.1.1
5.1.2
5.1.3
10 en | Configuration AMAX 2100 / 3000 / 4000
2014.03 | 01 | Quick Start Guide Bosch Sicherheitsysteme GmbH