Specifications

RADION PIR
The RFPR-12 is a high performance PIR motion detector that uses advanced signal processing.
An integrated wireless transmitter sends a battery report with each transmission, and
transmits a supervisory signal to the control panel. Features include:
– 12 m x 12 m (40 ft x 40 ft) coverage
– Flexible Mounting Height
Dimensions 111.00 mm x 60.00 mm x 43.00 mm
(4.40 in x 2.40 in x 1.70 in)
Relative humidity Up to 93%, non-condensing
Temperature (operating) Functional range: -10°C to +49°C (+14°F to +120°F)
UL only: 0ﾟC to +49ﾟC (+32ﾟF to+120ﾟF)
EN 50130-5 Class II only: -10ﾟC to 40ﾟC (+14ﾟF to
+104ﾟF
Power/voltage One CR123A Lithium battery, 3 VDC ( )
Battery replacement Duracell DL123A , Panasonic CR123A, or Sanyo
CR123A. Check your battery yearly to ensure proper
functionality.
Battery life Up to 5 years
Device testing To ensure proper functionality, the device must be
tested at least once every year by an installer.
Wall and cover tamper switch Transmits a tamper signal when someone removes the
device from its base or pulls it away from the wall.
Frequency 433.42 MHz
Table 7.1: Specifications
Walk testing
Perform a walk test to determine the boundaries of the coverage area.
Insert a slotted screwdriver into the designated hole to open the cover and then close the
detector cover to start a 90-sec Walk Test mode.
During this test mode, motion detected within the detector’s coverage area causes a
transmitted alarm and LED activation. Each alarm will also extend the Test Mode. Adjust as
necessary.
Notice!
Excessive use of the Walk Test Mode may reduce battery life. Use only for initial setup and
maintenance testing.
7
7.1
28 en | RADION PIR RADION receiver OP
02.2014 | 01 | F.01U.261.835 Reference Guide Bosch Security Systems, Inc