Technical data

TSplus Carousel Basic Equipment Guide R980 500 388 (6.2010)
Bosch Rexroth Corporation
25
Fitting the Flat-top Chain (cont.)
7. Now start installing the
chain from below. Feed the
chain under the idler wheel
and then over the idler
sprockets onto the out-feed
conveyor sections (Fig. 29).
8. Continue feeding the
chain onto and around the
conveyor sections, joining
new lengths as necessary.
The white chain cap can be
used to mark the master
link locations. (See Page 28
extending and breaking the
chain).
9. Bring the chain into the
Drive Sprocket FTC (Fig.
30).
10. Repeat the same for the
other side, and line up the
ends of the two chains, as
llustrated in (Fig. 31).
Fig. 29
Fig. 30
Fig. 31