Technical data

Bosch Rexroth Corporation
20
R980 500 388 (6.2010) TSplus Carousel Basic Equipment Guide
Extend the Conveyor: Curve Sections (cont.)
Fig. 19
NOTE: Curve sections are delivered
pre-assembled, complete with cross
links for proper spacing, as well as
guide blocks and guide rails for smooth
pallet transfer around curves. The
cross links on the pre-assembled curve
sections should not be removed or
loosened.
Attach the first 90/180 curve section
to the straight sections at the end
farthest from the drive module.
First, make sure that the two straight
sections are even by running a
straight edge from the end of one
straight section to the end of the
other (Fig. 19). Check the alignment
at both ends of the conveyor.