Technical data

TSplus Carousel Basic Equipment Guide R980 500 388 (6.2010)
Bosch Rexroth Corporation
19
Extend the Conveyor: Straight Sections
1. Pre-install the mounting
hardware into the 4-hole
connection links. Slide the
connection links into the
T-slots of each conveyor
section, spanning the joint
evenly.
2. Slide the next conveyor
section onto the leg set
and connection links and
support the other end with
an additional leg set (Fig.
18).
3. Use the transit to raise the
new section to the proper
height and verify that the
line is level end-to-end and
side-to-side.
4. Tighten the flange nuts on
the gussets and the bolts
on the connection links to
18lb.ft. (25 Nm).
5. Repeat this process for
each conveyor section.
Conveyor
Profiles
13mm
Fig. 18