Technical data

TSplus Carousel Basic Equipment Guide R980 500 388 (6.2010)
Bosch Rexroth Corporation
17
NOTE: The drive module must be at-
tached at the end of the conveyor’s
longest continuous straight section
(Fig. 16).
CAUTION!
Overtightening the bolts may cause
damage to the aluminum profiles. To
avoid damage, tighten all threaded
fasteners in the TSplus conveyor
frame to 18lb.ft. (25 Nm).
4. Attach a pre-assembled
leg set to the module strut
profiles (Fig. 15). Torque
the bolts on the connection
links to 18lb.ft. (25 Nm)
using a metric 13mm torque
wrench.
5. Carefully lower drive
module onto the floor so
that the leveling foot just
touches the floor. Make sure
that the floor area is clean.
Keep module suspended
and balanced and perform
the next step.
6. Attach standard SZ2/E leg
set with 4 gussets to the
In-feed conveyor section.
Adjust the conveyor profile
so that it’s exactly centered
in the T-slot on the side
of the leg set (See Fig. 17
page 18).
7. Tighten the flange nuts in
the gussets to 18 lb.ft. (25
Nm) using a 13 mm wrench.
Fitting Leg Sets to the Carousel Drive Module (cont.)
Connection
Links
Fig. 15
Fig. 16
Max. Length = 30.5 meters