Technical data

TSplus Carousel Basic Equipment Guide R980 500 388 (6.2010)
Bosch Rexroth Corporation
15
Some leg sets will use gussets
in place of cross connectors to at-
tach the cross links. In this case, the
cross links will not have milled slots,
and the gussets attach to the vertical
posts and cross links using T-bolts
and flange nuts.
1. Use cross links (2) to join
the pre-assembled vertical
posts (1). Position the cross
links so that the milled slots
are on the underside of the
cross links, as shown in Fig.
12.
NOTE: If assembling the leg sets
on a table or other horizontal work
surface, place shims (approx. 7.5
mm thick) beneath the cross links
so that the cross link T-slots line
up with the vertical post T-slots.
2. Align the cross link T-slots
with the T-slots on the
vertical posts and fasten
the cross links to the
vertical posts using the
cross connector kits (3).
The upper cross links must be flush
with the top ends of the strut profiles;
the lower cross link must be mounted
at a specific distance (S in Fig. 12)
from the lower ends.
Leg Set Assembly
1
2
3
1
2
S
SZ 2/EH, SZ 2/UH & SZ 2/TH
SZ 2/E, SZ 2/U & SZ 2/T
CAUTION!
Overtightening the screws may cause damage to the aluminum profiles.
To avoid damage, tighten all threaded fasteners to 18 lb-ft. (25 Nm) using a
torque wrench.
Check for corner squareness with a 90° square and then firmly tighten all
screws and bolts.
SZ 2/E
Fig. 12