Technical data

Bosch Rexroth Corporation
14
R980 500 388 (6.2010) TSplus Carousel Basic Equipment Guide
NOTE: The assembly instructions that follow describe the installation of a basic, single-level TSplus transport system.
The assembly of other configurations is similar.
Assembly
Leg Set Assembly
Leg sets are shipped pre-assembled
from the factory. Assembly instructions
are included for adjustment and refer-
ence purposes.
NOTE: Careful pre-assembly of the leg
set will save time during leveling and
alignment. It is particularly important
to make sure that the leveling feet are
all screwed in to the same depth.
Pre-assemble the
Vertical Posts
1. Set the M16 (A/F 24) hex
nut on the leveling foot to
45 mm (Fig. 11).
2. Grease the first 50 mm of
the threaded shaft so that
screw-in and subsequent
adjustment are easier.
3. Screw the leveling foot in
by hand until the hex nut
touches the end of the strut
profile.
NOTE: Do not tighten the hex nut com-
pletely until the entire conveyor has
been set up and aligned.
Recommended Tools
The following tools are recommended
for assembling the basic system:
1 metric hex wrench set and torque wrench
1 metric Allen wrench set
1 pair spring-washer pliers A2
1 caliper gauge
1 90° square
1 soft-faced hammer
1 spirit level (2 - 3 ft.)
1 alignment cord
1 chainbreaker
1 chain assembly tool
(supplied with your kit)
1 Fishtape or other thin
plastic-coated wire for
feeding the chain.
Chain
Assembly
Tool
Chainbreaker
2
1
50mm
45mm
3
Fig. 11