Technical data

TSplus Assembly Conveyors
8981 500 278 7/09
Bosch Rexroth Corporation
14
WARNING!
• Useaqualiedtechnicianwhoisfamiliarwiththecontrol
system during the initial start-up.
• Incaseofcontrolsystemfailure,DONOTattemptto
catch or in any way prevent a pallet from falling from the
end of the conveyor. Use the emergency stop switch to
halt conveyor movement!
• KEEPHANDSCLEARofmovingconveyorsandpallets.
Pallet accumulation creates a crush hazard between
pallets, stop gates, and guide rails. A crush and pinch
hazard exists between Lift-Position Units, Lift-Transfer
Units, and Lift-Rotate Units. Assembly operations should
be performed ONLY when the workpiece pallet has
come to a complete stop.
• DONOTperformpressingoperationsonaworkpiece
pallet without the use of a Lift-Position Unit.
• DONOToperatetheconveyororanyothercomponents
in the system with the guards removed. It is the opera-
tor’s responsibility to make sure that all guards, covers,
and other safety equipment is in place before the system
is put into operation.
CAUTION!
• Donotoperateorworknearmechanicalequipmentwhen
wearing loose clothing. Moving components such as roller
chain, drive belts, drive shafts and pallets can snag long
belts, scarves, ties and other loose fitting garments, pull the
worker into the equipment and cause serious, or in extreme
cases, life threatening injury.
• Operators having long hair must wear appropri-
ate head protection (hair nets, hats, and hair caps)
to minimize the risk associated with working near moving
machinery. Hanging hair can get caught in moving compo-
nents such as roller chain, drive belts, drive shafts and pal-
lets, pull the worker into the equipment and cause serious,
or in extreme cases, life threatening injury.
The TSplus conveyor is designed to trans-
port Bosch WT2 workpiece pallets or WT2
workpiece pallet frames with integrated
fixtures built into the pallet design. Since
the conveyor is modular in design and part
of a larger operating assembly system, it
is the responsibility of the integrator or
end user to provide a control system and
Operating Instructions
operating procedures. For your safety,
please observe the following guidelines
when operating the conveyor: