Operation Manual

PowerBoost function en
15
Once the time has elapsed
The hotplate switches off. A warning signal sounds. The
time program function lights up
‹‹ for 10 seconds in
the display.
When the 0 symbol is pressed, the indications turn off
and the beeping stops.
Notes
■ To set a cooking time of under 10 minutes, always
touch 0 before you select the required value.
■ If a cooking time was programmed for several
hotplates, the time information for the selected
hotplate is shown in the timer display.
■ Select the relevant hotplate to call up the remaining
cooking time.
■ You can set a cooking time of up to ŠŠ minutes.
The kitchen timer
You can use the kitchen timer to set a time of up to 99
minutes.
This functions independently from the hotplates and
from other settings. This function does not automatically
switch off a hotplate.
Setting
1. Touch the 0 symbol repeatedly until the V
indicator lights up. ‹‹ lights up on the timer display.
2. Set the desired time in the settings area.
After a few seconds, the time begins to elapse.
Changing or deleting the time
Touch the 0 symbol repeatedly until the V indicator
lights up.
Change the time in the settings area or set ‹‹ in order
to delete the programmed time.
When the time has elapsed
An audible signal sounds. ‹‹ appears on the timer
display and the V indicator lights up. The displays go
out after 10 seconds.
When the 0 symbol is touched, the displays go out
and the audible signal ceases.
vPowerBoost function
PowerBoost function The PowerBoost function enables you to heat up large
quantities of water faster than when using heat setting
Š.
This function can always be activated for a hotplate,
provided the other hotplate in the same group is not in
use (see illustration). Otherwise,
› and Š will flash in
the display for the selected hotplate; the
Š heat setting
will then be set automatically without activating the
function.
Note: In the combi zone, the PowerBoost function can
only be activated if the two hotplates are used
independently of each other.
Activation
1. Select a hotplate.
2. Touch the á symbol.
› lights up on the display.
The function is activated.
Deactivation
1. Select the hotplate.
2. Touch the á symbol.
The › display goes out and the hotplate switches
back to the Š heat setting.
The function is deactivated.
Note: In certain circumstances, the PowerBoost
function can switch itself off automatically in order to
protect the electronic elements inside the hob.

