Technical data

5-30 Bosch Rexroth AG | Electric Drives and Controls Rexroth VCP-Operating Concept | R911305038 / 01
Standard Mode
The documentation value is also used for project documentation
instead of a real controller value.
5.5.7 Limits
In the programming software, you can specify a lower and an upper
limit for each variable to restrict operator input.
The lower limit is automatically set to 0 for variable values that are dis-
played with the attribute Only Positive.
If the operator tries to enter a value outside of these limits, one of the
following system messages is issued:
– Value too small
– Value too large
The operator can ignore these system messages, but he must enter a
value that lies between the limits, or use the Cursor Up or Cursor Down
keys to go to another variable in the mask. The system then accepts
the current controller value again.
See chapter “Documentation“ on page 5-192.