Technical data

R911305038 / 01 | Rexroth VCP-Operating Concept Electric Drives and Controls | Bosch Rexroth AG 5-25
Standard Mode
Example of a curve display:
Fig. 5-18: Example for displaying a curve
5.5.3.10 Fields
You can add fields to masks, to carry out specific tasks. Depending on
the type of field added, the mask can be a message mask, recipe
mask, or table mask. At runtime, you can display the messages sent by
the PLC in the message field of a message mask. For a recipe mask,
you must set up a recipe field to display the contents of a recipe. In the
table field of a mask, data is displayed in tabular form.
Message Field
The message field refers to the area in a mask that is used to display
messages.
To create a message field, carry out the following steps:
1. Select the Message Field icon in the toolbar and in the mask select
the area where messages will be displayed.
This area is displayed as a rectangle. The message field is marked
with the letter M on the left edge of the rectangle.
2. You can use the sizing handles to change the height of the area. You
cannot change the width of the area.
3. In the Message System area, determine whether messages of the
parallel message system or the serial message system will be dis-
played in the current message field.
You can determine the height of the message field in the Height of
Message Field area. A message field can have a maximum height of
60 lines.