Technical data

5-24 Bosch Rexroth AG | Electric Drives and Controls Rexroth VCP-Operating Concept | R911305038 / 01
Standard Mode
Example of fill status display: Four graphics have been created for the example. They display a con-
tainer that is either empty or full. The word MIN is used to demonstrate
a situation in which the value is not reached. And the word MAX to
depict a situation in which the value is exceeded. The container in the
middle depicts a container for a case where the operating device dis-
plays a mid-point controller value for the variables.
Fig. 5-17: Example of fill status display
5.5.3.9 Curve
Use the representation type Curve to display a value table as a row of
points in the operating device.
The address for the controller variable represents the start of the value
table in the controller. Each value in the table describes one pixel of the
curve.
A curve is defined by the following parameters:
– Maximum width (54 pixels for each curve variable)
– Maximum height (height of the display in the operating device)
Specify a length and height to determine the dimension of the curve in
the unit 'Character'.
To produce a curve with a width of 54 pixels, several curve variables
next to each other are required.
Insert a coordinate grid as a background image.
The operating device reads the variable values as an array from the
controller, and inserts these as continuous consecutive height data.
The value with the starting address (address +0) is displayed on the
very left. Each subsequent piece of height data (address +n) is offset
one pixel position to the right.
The height data for the curve is cyclically refreshed.