Technical data

R911305038 / 01 | Rexroth VCP-Operating Concept Electric Drives and Controls | Bosch Rexroth AG 5-23
Standard Mode
Fig. 5-16: Vertical bars
The range of values is limited to values from -32768 to +32767.
To display several bars in a mask, ensure that the controller addresses
are consecutive and contiguous. This will speed up data transfer.
You can use four fill patterns for bars:
1. For the empty area of the bar (background).
2. For the filled area of the bar (foreground).
3. For the bar, if the lower value is not reached.
4. For the bar, if the higher value is exceeded.
The programming software contains four standard fill patterns. You can
use any other images as fill patterns. Prior to use, you must import
these images into the programming software or insert them as OLE.
See chapter “Images“ on page 5-108.