Technical data

5-22 Bosch Rexroth AG | Electric Drives and Controls Rexroth VCP-Operating Concept | R911305038 / 01
Standard Mode
You use the height and width values to determine whether the bars run
horizontally or vertically. From a particular reference point, the dimen-
sion of a bar can be:
– in a positive direction
– in a negative direction
– in both directions
Specify the width and height in the unit 'Character'. The entire bar can
only ever accept the size of a multiple of a character. When the control-
ler values are output, however, the bar changes its dimension by pixel
size.
You use two values to define the range of values that a bar will display.
Use the first value to definethe value of the bar on the left or bottom
end.
Use the second value to define the value of the bar on the right or top
end.
Fig. 5-15: Horizontal bars