Technical data

5-16 Bosch Rexroth AG | Electric Drives and Controls Rexroth VCP-Operating Concept | R911305038 / 01
Standard Mode
5.5.3.3 Selection Text
You can choose to display a text instead of a numeric value. To do this,
you must create a text list.
In the text list, you assign numeric values to the corresponding texts.
The operating device reads the value of the variable from the control-
ler, replaces the numeric value with text, and displays this text. If a
value is read from the controller, and you have not defined a corre-
sponding text for this value, the system displays a number of question
marks.
If the Selection Text type is used for an input variable, you can choose
to limit the field height to one or several lines.
Minus Enters the numbers 0 to 9, the letters A to Z and a to z \*/- \*/\*/-
Cursor Right Moves the cursor one position to the right.
Cursor Left Moves the cursor one position to the left.
Cursor Up Moves the cursor to the next highest, editable variable
in the display, and selects it. If the cursor is already po-
sitioned at the top-level variable, the lowest-level vari-
able is selected.
Cursor Down Moves the cursor to the next lowest, editable variable
in the display, and selects it. If the cursor is already po-
sitioned at the lowest-level variable, the top-level vari-
able is selected.
Delete Deletes the character at the cursor position.
Key Function With
Shift
With Shift-
Case
Fig. 5-8: Key functions for alphanumeric variables