Technical data

5-12 Bosch Rexroth AG | Electric Drives and Controls Rexroth VCP-Operating Concept | R911305038 / 01
Standard Mode
5.5.1 Symbolic Name
In the programming software, you assign a symbolic name to each
variable. This name can have up to 255 characters.
5.5.2 Controller Address
You use the controller address to specify the storage location in the
controller.
Depending on the protocol selected, the system carries out a syntax
check. To avoid incorrect input, you can call a syntax diagram for each
protocol in the online help for the programming software.
5.5.3 Representation Type
You can choose from the following options for displaying variables on
the operating device
– Decimal number
– Alphanumeric
– Selection text
– Selection image
– Floating point number
– Hexadecimal number
– Binary number
–Bars
–Curves
5.5.3.1 Decimal Number
Standard
The significance of the displayed digits increases from right to left. You
can display places either with leading zeros and/or a decimal point.
The representation refers to the data types bit, byte, word, and Lword.
The maximum length depends on the data type. There are no blanks
between the characters. The variable appears in the controller either in
binary format or in special timer or counter formats.
Note whether a variable will be accessed on a byte, word, or double-
word basis.