Technical data

R911305038 / 01 | Rexroth VCP-Operating Concept Electric Drives and Controls | Bosch Rexroth AG 6-97
DIN Measurement Bus
Data Bits
This parameter specifies the number of data bits.
Stop Bits
This parameter specifies the number of the stop bits.
Slave Number
You can enter the slave number for the relevant slave terminal here. To
load the same project on all slave terminals, you can set an invalid
slave number here. You must then use the system variable ComSla-
veNr. in the setup mask during runtime to set a correct slave number.
Any invalid values are set to the value 255 (0xFF) when the operating
device is started up.
Configurable
Values
Default Value
5
6
7X
8
Fig. 6-149: Data bits, DIN Measurement Bus master
Configurable
Values
Default Value
1X
1.5
2
Fig. 6-150: Stop bits, DIN Measurement Bus master
Configurable
Values
Default Value
1 to 31 0
Fig. 6-151: Slave number, DIN Measurement Bus master