Technical data

6-68 Bosch Rexroth AG | Electric Drives and Controls Rexroth VCP-Operating Concept | R911305038 / 01
Bosch BUEP19E
Error from Programmable Controller
3 1 Addressed module does not exist
16 Module cannot be addressed
35 The address field has been protected by the
user
36 Access to this address field is not permitted
37 Writing to timer is not allowed
38 Block number too large
39 Block does not exist
40 Block too small
147 Flag area (CL200 only) exceeded Flag area defined is outside
of BYM0 to BYM191
4 32 Addressed data type (command code) unknown
in PST (peripheral station)
33 Protocol code unknown in PST
35 Specified coordination flag unknown in PST
37 Parameter code in telegram and specified para-
meters do not match
38 Block length and actual number of data do not
match
40 Telegram type unknown
41 Command type unknown
58 Starting address and operand type do not match
(word at odd address)
Defective R500 module
possible
59 Starting address outside of specified address
range
60 Invalid parameter for specified command
61 Invalid operand type
64 PST has not received an identification telegram
99 Specified data length greater than addressed
data area
210 Coordination flag is disabled
Error from Operating Device
40 System variable error Undefined system variable
Code Subcode Error Type Possible Cause
Fig. 6-103: Error Messages for Bosch BUEP19E